HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 146)

Virtual Connect server profiles 146
The following table describes the fields within the Flex-10 iSCSI Connections screen.
Item Description
Use Boot Assistant
Launches the iSCSI Boot Assistant (on page 148 ). For LHN, you can use the iSCSI Boot
Assistant to retrieve and populate most of the configuration and authentication data in
this screen.
iSCSI Boot
Configuration
Initiator Name Name used for the iSCSI initiator on the booting system. This name is the IQN name for
the host that is created by the storage administrator. The initiator name length can be
a maximum of 223 characters.
Target Name Name of the target from which to boot. This is the IQN name for the storage device that
is provided by the storage administrator during the LUN setup. The target name length
can be a maximum of 223 characters.
Boot LUN The LUN of the target identifies the volume to be accessed. Valid values for standard
LUNs are 0-255 decimal. Valid values for extended LUNs are 13- to 16-character
hexadecimal values.
Target Primary IP
Address Primary IP address used by the iSCSI target
Target Primary Port
The TCP port associated with the primary target IP address. The default value is 3260.
Target secondary IP
Address
Alternate target IP address to use if the primary port is unavailable
Target secondary Port The TCP port associated with the secondary target IP address. The default value is
3260.
Initiator Network
Configuration
VLAN id The VLAN number that the iSCSI initiator uses for all sent and received packets. Valid
values range from 1 to 4094.