HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 35)

Virtual Connect domains 35
The VC-Enet SNMP settings apply to all VC-Enet modules in the Virtual Connect domain.
The following table describes the fields within the SNMP Configuration screen.
Field name Description
Enable SNMP Select to enable SNMP.
System Contact Specify a contact name for this system when SNMP is enabled.
Read Community Controls SNMP read access when SNMP is enabled. The default value for read
community string is "public". The read community string must always be set when
SNMP is enabled. The maximum length is 39 characters.
SNMP Trap Destinations SNMP trap destination table
Destination User-designated name for the trap destination. The Destination name must be
unique.
IP Address IPv4 address or DNS name for the trap destination
Community String The Community String acts like a password for a given trap destination. The
trap-receiving application can use the community string to filter the incoming traps.
Default: public
Format Format of the new trap. Select SNMPv1 or SNMPv2.
Action Perform edit and delete operations
The following table describes the available actions in the SNMP Configuration screen. Clicking another link
in the pull-down menu or left navigation tree causes current edits that have not been applied to be lost.
Task Action
Add an SNMP trap destination
("
Adding an SNMP trap
destination " on page 36 )
Click Add below the destination table, or right-click on the header row of
the destination table, and then select Add Destination.