HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 193)

Virtual Connect modules 193
Port Statistic Description
Dot3StatsInternalMacReceiveErrors A count of frames for which reception on a particular interface fails due to
an internal MAC sublayer receive error. A frame is only counted by an
instance of this object if it is not counted by the corresponding instance of
either the dot3StatsFrameTooLongs object, the dot3StatsAlignmentErrors
object, or the dot3StatsFCSErrors object. The precise meaning of the
count represented by an instance of this object is implementation-specific.
In particular, an instance of this object may represent a count of receive
errors on a particular interface that are not otherwise counted.
Dot3StatsSymbolErrors For an interface operating at 100 Mb/s, the number of times an invalid
data symbol occurred when a valid carrier was present. For an interface
operating in half-duplex mode at 1000 Mb/s, the number of times the
receiving media is non-idle (a carrier event) for a period of time equal to
or greater than slotTime, and during which there was at least one
occurrence of an event that causes the PHY to indicate 'Data reception
error' or 'carrier extend error' on the GMII.
For an interface operating in full-duplex mode at 1000 Mb/s, the number
of times the receiving media is non-idle (a carrier event) for a period of
time equal to or greater than minFrameSize, and during which there was
at least one occurrence of an event that causes the PHY to indicate 'Data
reception error' on the GMII. The count represented by an instance of this
object is incremented, at most, once per carrier event, even if multiple
symbol errors occur during the carrier event. This count does not increment
if a collision is present.
Dot3ControllnUnknownOpcodes A count of MAC Control frames received on this interface that contain an
opcode that is not supported by this device.
Dot3InPauseFrames A count of MAC Control frames received on this interface with an opcode
indicating the PAUSE operation. This counter does not increment when the
interface is operating in half-duplex mode.
Dot3OutPauseFrames A count of MAC Control frames transmitted on this interface with an
opcode indicating the PAUSE operation. This counter does not increment
when the interface is operating in half-duplex mode.
IfHCInOctets The total number of octets received on the interface, including framing
characters. This object is a 64-bit version of ifInOctets.
IfHCInUcastPkts The number of packets, delivered by this sublayer to a higher sublayer,
which were not addressed to a multicast or broadcast address at this
sublayer. This object is a 64-bit version of ifInUcastPkts.
IfHCInMulticastPkts The number of packets, delivered by this sublayer to a higher sublayer,
which were addressed to a multicast address at this sublayer. For a MAC
layer protocol, this includes both Group and Functional addresses. This
object is a 64-bit version of ifInMulticastPkts.
IfHCInBroadcastPkts The number of packets, delivered by this sublayer to a higher sublayer,
which were addressed to a broadcast address at this sublayer. This object
is a 64-bit version of ifInBroadcastPkts.
IfHCOutOctets The total number of octets transmitted out of the interface, including
framing characters. This object is a 64-bit version of ifOutOctets.
IfHCOutUcastPkts
The total number of packets that higher-level protocols requested be
transmitted, and which were not addressed to a multicast or broadcast
address at this sublayer, including those that were discarded or not sent.
This object is a 64-bit version of ifOutUcastPkts.