PreSonus StudioLive 24.4.2 - Manual (Page 93)

6 Capture
6.5 Capture Session Navigation
StudioLive ™ Software Library
Reference Manual
89
6.4.3 Capture Main Source Selection (StudioLive 16.4.2 and 24.4.2 only)
The Auxiliary Stereo Track in Capture is a stereo channel intended to be used to
record a stereo mix from your StudioLive. This mix can be recorded while recording
the individual input channels, so a mix is available immediately after a live show, or
you can use this channel to route your final studio mixes through the StudioLive.
As discussed in Section 3.7.1, VSL features an Auxiliary Inputs Router that allows
you select which buses you want to record in addition to your input channels.
Auxiliary Inputs 25-26/17-18 are dedicated for recording a stereo mix in Capture.
However, in addition to the Main L/R mix, you can select from any of the following
outputs, buses, and inputs: Sub 1/2, Sub 3/4, Aux 1/2, Aux 3/4, Aux 5/6, Aux 7/8
(24.4.2 only), Aux 9/10 (24.4.2 only), EFX Send A, EFX Send B, Aux Return A, Aux
Return B, Tape In, Talkback, EFX Return A, EFX Return B, and the Solo bus.
6.5 Capture Session Navigation
The ability to quickly navigate to certain areas of your Session
is highly useful during mixing. The following describes the
ways in which you can quickly navigate your Session.
6.5.1 Scrolling
To scroll left and right through time in your Session, click and drag
the horizontal scroll bar near the bottom of the Edit window.
You can also scroll through your session by clicking
and drag the Timeline Ruler left or right.
6.5.2 Timeline Zooming
You can zoom in and out of your Session with respect to time in the
Edit window, so that you can look at the entire length of the Session
or just view a small region of time to make accurate edits.
To zoom, do one of the following:
• Click-and-drag left or right on the Horizontal Zoom scroll bar in the lower
right-hand corner of the Edit window to zoom in or out.
• [W] on the keyboard to zoom out slightly. Press [E]
on the keyboard to zoom in slightly.
• Click inside the Timeline ruler at any point in time
and drag down or up to zoom in or out.