PreSonus StudioLive 24.4.2 - Manual (Page 54)

3 Universal Control and VSL
3.8 Smaart System Check Wizards (StudioLive 16.4.2 and 24.4.2 only)
StudioLive ™ Software Library
Reference Manual
50
7. Place your microphone on-axis in front of the speaker you
want to delay. See Section 3.8.5 for tips in choosing the best
primary mic position.
8. Click OK when your microphone is properly placed.
9. Raise the fader until the pink noise outputted through your main system (the
speaker to which you want to align) is louder than the ambient noise floor in the
room. At the appropriate measurement level, you should not hear the air
conditioning, traffic noise from the street, etc.
10. To mute the pink noise at any time, simply click on the Speaker icon.
11. Click Analyze.
12. If necessary, adjust the pink noise level for your delay system (the speaker you
want to delay) so that it is louder than the ambient noise floor in the room.
13. Click Analyze to calculate the delay time.
14. When the wizard is finished, you will be shown the measured
delay time.
1