PreSonus StudioLive 24.4.2 - Manual (Page 83)

5 QMix for iPhone and iPod touch
5.4 Settings Page
StudioLive ™ Software Library
Reference Manual
79
Wheel of Me. Controls the Level of the Me Channels
The Wheel of Me increases or decreases the level of your Me channels as a mix
relative to the rest of the channels (the Band). If you increase the level of your Me
channels beyond the top level, the other channels will decrease in volume.
On either side of the Wheel of Me, you will find Me and Band mix indicators. These
level displays show the balance between the Me channels and the Band channels.
The Band channels consist of any channels not identified as Me channels. These
indicators will adjust automatically as you move the Wheel of Me up or down.
5.4 Settings Page
To open the Setting page, tap on the Settings button on the Aux Mix page or Wheel
of Me page. From the Settings page, you can customize your QMix scrolling and
create custom names for each channel and aux mix.
Scroll by Page. Scrolls through Channels by Page.
When the Scroll by Page option is enabled,
the mixer will scroll through channels by
entire pages, rather than by individual channels. Turning this option off will
allow you to scroll one channel at a time, offering more granular control.
Peak Hold Metering. Displays the Last Signal Peak.
When Peak Hold Metering is enabled, each meter in
QMix will continue to display the most recent signal
peak. This allows you to keep an eye on the average loudness of each channel’s signal.
Channel Naming. Creates Custom Names
for Channels, Auxes, and Subgroups.
To create a custom name for any channel, aux, or subgroup
(16.4.2 and 24.4.2 only) in your mix, simply tap on the text field
next to it. This will launch the iPhone/iPod touch keyboard. After
you have entered the new name, tap the Done button. The default
name will be replaced with the new custom name in SL Remote,
VSL, and QMix.
Please Note: Channel Naming can be disabled in Universal Control.
If you are unable to change channel names from QMix, verify your
device’s permissions in the Setup tab in Universal Control.