Burkert Type 8793 - Manual (Page 47)

47
Installation
Type 8792, 8793
english
12.4.2. Connection and start-up of the Remote Sensor Type 8798
WARNING!
Risk.of.injury.from.improper.start-up!
• Start-up may be carried out by authorised technicians only and with the appropriate tools!
Risk.of.injury.from.unintentional.activation.of.the.system.and.an.uncontrolled.restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
→
Connect the 3 or 4 wires of the sensor cable to the designated screw-type terminals of type 8792/8793.
Connection.of.screw-type.terminals: See chapter “15.2.4. Terminal assignment for external position sensor
(for remote model only)”, page 58.
Connection.of.M8.circular.connector (only for PROFIBUS and DeviceNet)
: See chapter PROFIBUS “29.5”,
page 195 / DeviceNet “32.5”, page 214.
→
Attach Remote Sensor on the actuator.
The correct procedure is described in the brief instructions for the Remote Sensor.
→
Connect compressed air to Type 8792/8793.
→
Connect Type 8792/8793 pneumatically to the actuator.
→
Switch on operating voltage to the Type 8792/8793.
→
Run the X.TUNE function.