Burkert Type 8793 - Manual (Page 107)

107
Auxiliary functions
26.2. Overview and description of the auxiliary functions
CHARACT ADD.FUNCTION
CUTOFF
DIR.CMD
DIR.ACT
SPLTRNG *
X.LIMIT
X.TIME
X.CONTROL
P.CONTROL
SECURITY
SAFEPOS
SIG.ERROR
BINARY.IN
OUTPUT
CAL.USER
SET.FACTORY
SER. I / O
EXTRAS
SERVICE
SIMULATION
DIAGNOSE
POS.SENSOR
Selection of the transfer characteristic between input signal
and stroke (correction characteristic)
Sealing function for positioner
Sense of effective direction between input signal and set-
point position
Assignment of the aeration state of the actuator chamber to
the actual position
Signal split range; input signal as a % for which the valve runs
through the entire stroke range.
Limit the mechanical stroke range
Limit the control speed
Parameterization of the positioner
Parameterization of the process controller
Code protection for settings
Input the safety position
Configuration of signal level fault detection
Activation of the binary input
Configuration of outputs (option)
Calibration
Reset to factory settings
Configuration of serial interface
Adjusting the display
Simulation of set-point value, process valve, process
For internal use only
Diagnosis menu (option)
Setting interface remote path sensor
(available for Type 8793 Remote only)
ENTER
EXIT
* The SPLTRNG auxiliary function can only be selected if P.CONTROL (process control) is not activated.
Figure 51: Overview - auxiliary functions
english
Type 8792, 8793