Burkert Type 8793 User Manual

Page 27

Description of System

Configurable.auxiliary.functions

Effect

SERVICE

For internal use only

Simulation software
SIMULATION

For simulation of the device functions

DIAGNOSE (Option)

Monitoring of processes

POS.SENSOR

Table 5:

The process controller software. Configurable auxiliary functions of the position controller

Functions.and.setting.options.of.the.process.controller
Process controller
P.CONTROL

PID - Process controller is activated

Adjustable parameters
P.CONTROL - PARAMETER

Parameterization of the process controller

Proportional coefficient, reset time, hold-back time and
operating point

Scalable inputs
P.CONTROL - SETUP

Configuration of the process controller

- Selection of the sensor input

- Scaling of process actual value and process set-point

value

Selection of the set-point value defaults

Automatic sensor detection or manual sensor
setting
P.CONTROL - SETUP - PV INPUT

Sensor types Pt100 and 4 – 20 mA are automatically
detected or can be set manually via the operating menu

Selection of the set-point value specification
P.CONTROL - SETUP - SP INPUT

Set-point value specification either via standard signal
input or via keys

Process characteristic linearization
P.Q‘LIN

Function for automatic linearization of the process
characteristics

Process controller optimization
P.TUNE

Function for automatic optimization of the process con-
troller parameters

Table 6:

The process controller software. Functions and setting options of the process controller

Hierarchical.operating.concept.for.easy.operation.on.the.following.operating.levels
Process level

On the process level switch between AUTOMATIC and
MANUAL mode.

Setting level

On the setting level specify certain basic functions during
start-up and configure auxiliary functions if required.

Table 7:

The process controller software. Hierarchical operating concept

English

Types 8792, 8793

This manual is related to the following products: