Burkert Type 8793 - Manual (Page 170)

170
Auxiliary functions
26.3.1.2. X.TUNE.POS – Setting of the end positions
In this menu you can specify whether the pneumatic actuator has mechanical end positions or not.
If there are no mechanical end positions available, these are not approached by the
X.TUNE and must be man-
ually specified.
Position.of.the.end.positions
Key Action Description
/ Select M.TUNE.POS
ENTER Press The selection for
ACT.limit = mechanical end positions available
ACT.nolimit = mechanical end positions not available
is displayed.
If.mechanical.end.positions.are.available
/ Select ACT.limit
SELEC Press The selection is marked by a filled circle .
EXIT Press Return to the Manual.TUNE menu.
If.mechanical.end.positions.are.not.available
/ Select ACT.nolimit
SELEC Press
The CAL.POS submenu for inputting the end positions is opened.
/ Select POS.pMIN
INPUT Press
The input screen for the value of the lower end position is opened.
/ OPN Open more
CLS Close more
Approach lower end position of the valve.
OK Press
Transfer and simultaneous return to the CAL.POS menu.
/ Select POS.pMAX
INPUT Press
The input screen for the value of the upper end position is opened.
/ OPN Open more
CLS Close more
Approach upper end position of the valve.
OK Press
Transfer and simultaneous return to the CAL.POS menu.
EXIT Press Return to the M.TUNE.POS. menu.
EXIT Press Return to the Manual.TUNE menu.
Table 96: M.TUNE.POS; position of the end positions
english
Type 8792, 8793