ALLIED Vision Technologies Guppy F-503 - Manual (Page 77)

Camera interfaces
GUPPY Technical Manual V7.1.0
77
GUPPY (board level)
The following diagram shows the I/O pin header (2.54 mm connector) of a
board level camera as viewed in pin direction:
Figure 34: GUPPY (board level): Camera I/O connector pin assignment
Note

GP = General Purpose
For a detailed description of the I/O connector and its oper-
ating instructions see the Hardware Installation Guide,
Chapter GUPPY input description.
Read all Notes and Cautions in the Hardware Installation
Guide, before using the I/O connector.
Pin Signal Direction Level Description
1 External GND GND for RS232, GPIOs
and ext. power External Ground for RS232,
GPIOs and external power
2 External Power +8...+36 V DC Power supply
3 GND
4 TxD RS232 Out RS232 Terminal Transmit Data
5 RxD RS232 In RS232 Terminal Receive Data
6 GND
7 Camera In/Out 4 In/Out
U
in
(high) = 2 V...5 V
U
in
(low) = 0 V...0.8 V
U
out
(high) = 2.4 V...5 V
U
out
(low) = 0 V...0.4 V
Camera Input/Output 4
(GPInOut4)
default: -
8 Camera In/Out 3 In/Out Camera Input/Output 3
(GPInOut3)
default: -
9 Camera In/Out 2 In/Out Camera Input/Output 2
(GPInOut2)
default: -
10 Camera In/Out 1 In/Out Camera Input/Output 1
(GPInOut1)
default: -
1
2
3
4
5
6
7
8
9
10