Example, B0 in, Table 132: advanced register: low noise bin – ALLIED Vision Technologies Guppy F-503 User Manual
Page 281: Ning mode, Mode see chapter, Low noise binning, Mode (2 x and 4 x binning) (only guppy f-503), See chapter, Low noise binning mode (2 x and 4 x bin, Ning) (only guppy f-503)
Configuration of the camera
GUPPY Technical Manual V7.1.0
281
The remaining visible Format_7 Mode_1 ... Mode_7 can be mapped to any
internal Format_7 mode.
Example
To map the internal Format_7 Mode_18 to the visible Format_7 Mode_1,
write the decimal number 18 to the above listed F7MODE_1 register.
Low noise binning mode (2 x and 4 x binning)
(only Guppy F-503)
This register enables/disables low noise binning mode.
This means: an average (and not a sum) of the luminance values is calculated
within the FPGA.
The image is therefore darker than with the usual binning mode, but the sig-
nal to noise ratio is better (approximately a factor of
).
Note
For available Format_7 modes see
sible Format_7 modes to F7M1...F7M7 on page 152
Setting the F7MODE_x register to:
•
-1 (hex. FFFFFFFF) forces the camera to use the factory
defined mode (Default)
•
-2 (hex. FFFFFFFE) disables the respective Format_7
mode (no mapping is applied this mode is no more
available and is not shown in the viewer e.g.
SmartView)
After setup of personal Format_7 mode mappings you have to
reset the camera. The mapping is performed during the cam-
era startup only.
Offset
Name
Field
Bit
Description
0xF10005B0
LOW_NOISE_BINNING Presence_Inq
[0]
Indicates presence of this feature
(read only)
---
[1..5]
Reserved
ON_OFF
[6]
Low noise binning mode on/off
---
[7..31]
Reserved
Table 132: Advanced register: Low noise binning mode
2