ALLIED Vision Technologies Guppy F-503 - Manual (Page 134)

Description of the data path
GUPPY Technical Manual V7.1.0
134
The following flow diagram illustrates the defect pixel correction:
Figure 72: Defect pixel correction: build and store
Note

While building defect pixel correction data or uploading them
from host, the defect pixel correction data are stored volatile
in FPGA.
Optional you can store the data in EEPROM non-volatile (Set
MemSave to 1).
Note

Configuration
To configure this feature in an advanced register: See Table
120: Advanced register: Defect pixel correction on page 268.
Set resolution to
Format_7 Mode_x
Or
Set resolution to
Format_7 Mode_0
when using fixed
modes.
Set AOI to max.
Set values for
shutter, gain,
brightness to max.
Do one-shot
Choose threshold
Set BuildDPData
to 1
Set ON_OFF to 1
Optional:
Set MemSave to 1