Ocean Optics OOISensors - Manual (Page 97)

6: Hardware Data Sheets and Instructions
Specification Value
Compensation Temperature
Probe reconditioning N/A – disposable sensor films
Re-calibration Required with each new film
Probe lifetime >1 year
Factory Calibration Services
When measuring oxygen, you normally must keep the sample at a constant temperature. However, if you
cannot maintain the sample at a constant temperature (+/-3 °C), you can perform a temperature calibration
using the calibration function in the OOISensors Software.
Ocean Optics can also perform the temperature calibration for your. The FOXY-CAL is an in-house
factory-calibration service for environments from 0 °C to 80 °C. The FOXY-CAL-EXT is a factory-
calibration service for extended temperature ranges below 0 °C or above 80 °C. You'll need to determine
the temperature and the oxygen concentration range of your sample before ordering an in-house
calibration service.
Calibration Option Temperature Range O2 % Range Price
FOXY-CAL 0 ºC to 80 ºC 0 to 100% $199.00
FOXY-CAL-EXT -20 ºC to 80 ºC 0 to 100% $299.00
FOXY-RECOV Probe Reconditioning
Occasionally, your probe overcoats may become compromised and require reconditioning. Ocean Optics
offers the FOXY-RECOV and FOXY-RECOV-N (for needle probes) probe reconditioning services.
When a probe overcoat becomes compromised, you will observe spectra similar to what is displayed
below:
FOXY-AL300-000-02-0207 87