Ocean Optics OOISensors - Manual (Page 78)

5: Compatible Products and Accessories
Part Number Description
FOXY-AF RTV healthcare-grade silicone overcoat for oxygen probes
FOXY-AF-MG
RTV high-strength medical implant-grade silicone overcoat for oxygen
probes (provides a thicker and stronger coating than the FOXY-AF)
FOSPOR-AF Overcoat for FOSPOR probes, RTV silicone
FOSPOR-AF-MG Overcoat for FOSPOR probes, medical-grade RTV silicone
FOSPOR-RECOV Oxygen sensor reconditioning/recoating service
HIOXY-RECOV Oxygen sensor reconditioning/recoating service
Temperature Compensating Components
http://www.oceanoptics.com/products/foxytempcomp.asp
Since oxygen probes are temperature dependent, temperature electrodes can be used in conjunction with
oxygen probes to compensate for temperature effects. The following table details the temperature probes
offered by Ocean Optics:
Part Number Description
FOXY-TK1
Omega K-type Thermocouple has 1/8" outer diameter, temperature range of
-150
° C to 220° C with accuracy of 2.2° C or 0.75% of reading with
precision of 1 ° C (requires FOXY-T-MOD-K module for data acquisition and
10-foot wire)
FOXY-TK-1-W
20-gauge K-type Wire Thermocouple with exposed end has temperature
range of -58°F to +392°F (requires FOXY-T-MOD-K module for data
acquisition)
USB-LS-450-TP
16-gauge needle type RTD only for use with the USB-LS-450; Temperature
range of -60 ºC to 600 ºC
Sol-Gel Coated Membranes, Microscope
Coverslips, and Slides
Ocean Optics’ sol-gel oxygen-sensitive film can be applied to any glass substrate, including membranes,
microscope coverslips, and microscope slides. Ocean Optics can also apply the oxygen-sensitive film to
other products, such as cuvettes and micro-well plates. The table below contains a list of off the shelf
products coated with the sol-gel:
68 FOXY-AL300-000-02-0207