Ocean Optics OOISensors - Manual (Page 107)

6: Hardware Data Sheets and Instructions
R-LS-450 Rack Mount Blue LED Pulsed Light Source
The R-LS-450 is shipped with the following jumper pin configuration:
• Jumper over pins in JP1
• Jumper over the Manual pins in JP3
• Jumper over the 2
10 pins in JP2 (for the fastest available pulse rate)
Configuring the R-LS-450 Board
You can configure the lamp’s performance through the use of a switch and three jumper blocks on the
circuit board of the R-LS-450 and, if desired, through one jumper block on the circuit board of the S2000
spectrometer. The following sections detail the different configuration options for the R-LS-450.
Determine the best mode of operation for your application, and configure your system accordingly.
S1 Switch
The S1 Switch on the R-LS-450 can be positioned in three modes: continuous wave operation, no
operation, and pulsed operation.
Jumper Block 1 (JP1)
There is one set of pins in JP1. If other jumper blocks are configured correctly, a jumper over JP1 allows
you to turn the R-LS-450 on and off via the Enable Strobe feature in OOISensors Software, and even
allows you to control the pulse rate through OOISensors’ Flash Delay feature.
FOXY-AL300-000-02-0207 97