Ocean Optics Cool Red - Manual

The Cool Red works beautifully as a complement
to mid-infrared analyzers or in any spectroscopy
application where high-intensity infrared light is
required. Cool Red is especially useful for ap-
plications in the region from 1000-5000 nm.
For systems that require optical modulation, an
integrated optical shutter can be modulated at
frequencies of up to 200 Hz.
The shutter can be driven externally through a 15-
pin digital interface. If no external drive is available,
the shutter can be driven internally by an integrat-
ed adjustable square wave generator.
Frequency can be continually adjusted through
the control knob on the front panel from 0.5 Hz
to 200 Hz. The digital output for this signal can be
taken from the same 15-pin interface and used to
synchronize other devices.
Cool Red
Infrared Light Source
www.oceanoptics.com | [email protected]
+1 727-733-2447
SPECTROMETERS | SAMPLING ACCESSORIES | WORLD CLASS SERVICE
Lamp
Material:
Silicon Nitride (Si3N4)
Temperature: 1500 ºK
Lifetime: 2,000 hours
Warm-up time: 12 seconds
Power: 50 Watts
Shutter
Shutter frequency:
200 Hz
Additional Information
Replacement lamps:
CR-Lamp-50W
Power Supply Requirements
5 amps, 24 volts
5.5 mm OD/3 mm ID
Universal input power supply included
Dimensions
127 mm x 127 mm x 114.3 mm
Spectral Output of Cool Red IR Source