Ocean Optics OOISensors - Manual (Page 21)

2: OOISensors Software
The System Type field in the upper, right corner allows you to select either Spectrometer or MFPF for
the attached hardware. The differences between the two system types when using OOISensors are noted
where applicable throughout this manual. Depending on this selection, some tabs and other user interface
objects will be visible (or not) in main application window and in this configuration window.
Notes
If you have an MFPF unit, refer to the MultiFrequency Phase Fluorometer Installation and
Operation Manual for more information. These instructions assume that you are installing
OOISensors to use with a spectrometer. If you switch between Spectrometer and MFPF System
Type, most parameter settings will be retained as they are hardware-specific, but some parameters
are common to all hardware types.
If you switch from MFPF to Spectrometer System Type, the spectral graph will not be visible.
You must select the Display tab on the Configure System screen, and then change the Graph
and Chart Display Mode to display the spectral graph.
FOXY-AL300-000-02-0207 11