Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 87)

Changing Printer Settings
87
IMPORTANT This change takes effect for all subsequent data and operations for the
printer as soon as the
↵ key is pressed and the asterisk (*) is displayed.
The configuration change(s) stay in effect only while the printer is
powered on. When the power is turned off, all current configurations will
be lost unless changes made to it are saved via the CONFIG. CONTROL
menu.
To save configuration information permanently or to select it as the power-up
default, see “Saving A Configuration” on page 88.
Changing Printer Settings
You can change (or “configure”) printer settings, such as print speed or
emulations, through the control panel as follows:
1. Press the key until the following message displays:
2. Press the ↓ key to cycle through these options:
• Print Intensity
• Print Speed
• Print Mode
• Media Handling
• Paper Feed Shift
• Label Length
• Label Width
• Ver Image Shift
• Hor Image Shift
• Orientation
• Gap/Mark Sensor
• Auto Calibrate
• Validator Function (if the validator option is installed. Refer to the
Online Data Validator User’s Manual.)
• Active IGP Emul
• Save Config.
• Power-Up Config.
• SMT: Status (if RFID is installed. Refer to the RFID Labeling
Reference manual.)
• PAA: Status (if RFID is not installed)
MENU MODE
QUICK SETUP
..
.