Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 274)

274
Chapter 3 BATTERY CONTROL
BATTERY CONTROL
BATTERY CONTROL Submenus
Battery Monitor
• Disable (the default). When set to Disable, the other Battery Control
menus do not display. The Serial Port is restored to normal use, and the
Serial Port menu displays.
• Enable. When set to Enable, the other Battery Control menus display.
The Serial Port is reserved for monitoring the power cart, and the Serial
Port menu does not display.
When Battery Monitoring has been enabled and the printer is online, the
second line of the LCD message displays the time remaining as “Batt
xxx.xx Hrs.”
The factory default is Disable.
BATTERY
CONTROL
(from page 105)
Battery
Monitor
Disable*
Enable
Time
To Go 1
Percentage
Charge 1
xxx.xx Hours 2 xxx.x% 2
Current
Draw 1
+/- xx.xx Amps 2
Voltage 1
xx.xx Volts 2
Amp-Hour
Used
1
+/- xx.x Amp-Hours 2
Time To
Go Alert 1
1.0 Hours*
.3 - 12.0 Hours
High Volt
Alert 1
16.0 Volts*
12.5 - 16.0 Volts
Low Volt
Alert 1
9.5 Volts*
8.5 - 11.5 Volts
Notes:
* = Factory Default
1 Available only when Battery Monitor is set to Enable (in the BATTERY
CONTROL menu). Functional only when the printer is connected to a
power cart, via serial interface, and the cart has an ICP (Intelligent
Control Panel) option.
2
You cannot change this value; it is a display only item.
Low Volt
Fault 1