Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 218)

218
Chapter 3
Ignore Spaces
• Disable. Trailing spaces are not deleted from alphanumeric elements in a
graphics pass.
• Enable. Trailing spaces are deleted from alphanumeric elements in a
graphics pass.
The factory default is Disable.
Ignore Text
• Disable. When disabled, text in normal mode will be printed. Attributes to
be printed depend on the PGL Normal menu setting.
• Enable. When enabled, any line of text (non-PGL commands) in normal
mode will be ignored.
The factory default is Disable.
IGP100 Compatibl.
This parameter forces the output to correspond with
IGP-100 printer output in cases where there are differences.
The options are Disable (the factory default) and Enable.
Intervention Req
• Send To Host. The printer sends a signal to the host computer when a
printer fault or hold mode time-out occurs.
NOTE: If you select Send To Host, make sure the Error Recover option
(under MEDIA CONTROL) is set to Disable. If Error Recover is not
set to Disable, Intervention Req will not work properly.
• Do Not Send. No signal will be sent to the host computer.
The factory default is Send To Host.
Italic Print
• Disable. Text is printed normally.
• Forward Slant. Text is printed with a forward slant.
• Backward Slant. Text is printed with a backward slant.
The factory default is Disable.
LAC Approx.
This item controls whether or not the LAC Approximation is used. (See the
Coax/Twinax Programmer’s Reference Manual.)
When set to On, then Approximation is used. When set to Off, Approximation
is not used, and incoming data will print as is. The factory default is On.