Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 196)

196
Chapter 3
Auto Skip at End
Specifies whether to perform an automatic form feed at the end of a print
buffer. If form feed is the last character in the print order, the form feed
function is supplied by the Auto Skip At End option.
• Off. Sets the printer to print at print position 1 of the next line.
• On. Sets the printer to print at print position 1 of the first line of the next
form.
The factory default is Off.
Auto Uppercase
This parameter enables the printer to print text in all uppercase when using
the ALPHA command.
• Disable. The printer will print text in upper and lowercase.
• Enable. The printer will print text in uppercase only.
The factory default is Disable.
Autoeject (VGL)
Determines paper handling upon exiting the VGL Repeated Form and
Dynamic Form commands.
• Disable. Holds the print position at the bottom of the form.
• Enable. Issues a form feed after the last form is printed so all pages will
be physically printed.
The factory default is Disable.
Autowrap
This parameter determines if text will wrap to the next line when the line of
text exceeds the right margin.
• Disable. Truncates the text beyond the right margin until a CR or CR + LF
is received.
• Enable. Automatically inserts a CR + LF after a full print line.
The factory default is Disable.
Barcode var.
This command only applies for IBARC barcode command format.
• Low Resolution. Sets barcode ratio dot values to be interpreted as line
matrix printer dots (60 x72).
• High Resolution. Sets barcode ratio dot values to be interpreted as print
engine dots (300 x 300 or 203 x 203).
The factory default is Low Resolution.