Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 333)

Fault Messages
333
LOADING
PROGRAM
FROM PORT XX% Yes The new emulation
program is loading into
printer RAM. XX%
indicates how much of
the program has
loaded. No action required.
LOADING
PROGRAM
INTO FLASH Yes A program is getting
loaded into flash. No action required.
MENU MODE
QUICK SETUP Yes Normal message that
displays when you first
press the MENU key to
place tje printer in
Menu mode when no
validator option is
installed. No action required.
INCOMPATIBLE
WITH CUTTER Yes Tear-Off or Peel-Off
Media Handling
selection was
attempted with the
cutter option still
installed. These modes
require that the front
door assembly be
installed to use the
Label Taken Sensor. 1. Select a different Media
Handling Mode.
2. Power off the printer and
remove the cutter option,
install the front door
assembly, power on the
printer and select Tear-Off
or Peel-Off Mode.
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution