Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 347)

Media
347
Figure 9. Media Dimensions
I. Tag Specification
(Mark Sensing)
II. Tag Specification
(Gap Sensing)
III. Label Specification
(Gap Sensing)
Direction of Media Motion
Black Mark (on underside)
Direction of Media Motion Direction of Media Motion
Recommended
Cross Perf
Location
Recommended
Cross Perf
Location
Table 20. Media Specifications
T5X04
SL5X04 MP2 T5X06
SL5X06 MP2 T5X08
A Label Width Range 0.75 -4.5 in.
19.1-114.3 mm 2.0-6.8 in.
50.8-172.7 mm 3.0-8.75 in.
76.2-222.3 mm
B Backing Width Range 0.75-4.5 in.
19.1-114.3 mm 2.0-6.8 in.
50.8-172.7 mm 3.0-8.75 in.
76.2-222.3 mm
C Min. Gap/Hole/Notch Height 0.10 in.
2.54 mm 0.10 in.
2.54 mm 0.10 in.
2.54 mm
K Min. Refl. Mark Height 0.10 in.
2.54 mm 0.10 in.
2.54 mm 0.10 in.
2.54 mm
I Min Refl. Mark Width 0.5 in.
12.7 mm 0.5 in.
12.7 mm 0.5 in.
12.7 mm
E Media Thickness Range .0025-.010 in.
.0635-.254 mm .0025-.010 in.
.0635-.254 mm .0025-.010 in.
.0635-.254 mm
G Width of Inter-label gap/hole 0.25-0.50 in.
6.35-12.7 mm 0.25-0.50 in.
6.35-12.7 mm 0.25-0.50 in.
6.35-12.7 mm
D Media Length Range
Continuous/Batch Mode 0.25 in. (6.35mm) - 99 in. (2515mm)
Tear-Off Strip Mode 0.25 in. (6.35mm) - 99 in. (2515mm)
Tear-Off Mode 1 in. minimum (25.4 mm) - 99 in. (2515 mm)
Peel-Off Mode
1 in. minimum (25.4 mm) - 99 in. (2515 mm)
(1)
Cut Mode 1 in. minimum (25.4 mm) - 99 in. (2515 mm)
These figures are approximate and depend upon the active emulation and application.
(1)
1.5 inch with validator support.