Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 220)

220
Chapter 3
Left Margin
Set in characters. Character zero is defined as the far left edge of the page,
and column numbering increments from left to right.
The range is 0-369 characters, and the factory default is 0 characters.
Logical Buf Size
Refers to the size of the printer buffer, which should be set the same as the
host screen (buffer) size. If the host screen size is unknown, use 1920.
The options are 960, 1920, 2560, 3440, and 3564.
The factory default is 1920.
LPI
This item selects the number of lines printed per inch.
The range is 6-10, and the factory default is 6.
Max PI 16
• Enable. A paper slew of 0-15 will move 1-16 lines.
• Disable. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will
always move 1 line.
The factory default is Enable.
Max. Print Width
Set the maximum print width the printer will print when using a C/T or TN5250
host interface. Set for 13.2 inches when printing files larger than the width of
the printer. All data exceeding the width of the maximum Printer Width will be
truncated.
• 13.2 inches
• Printer Width (the maximum width of the printer)
The factory default is 13.2 inches.
Midline PY (includes ^PN)
• Disable. The Graphics mode Enabled command, ^PY, must be the first
three characters of a line.
• Enable. The ^PY or ^PN can occur anywhere in a line.
The factory default is Disable.