Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 329)

Fault Messages
329
FAN WARNING Yes The printer detected
that the power supply
fan did not rotate for at
least 45 seconds when
it is was supposed to.
NOTE: This is a
warning message and
will not halt printing.
When too high of
internal temperature is
detected, based on its
source, the printer will
stop printing and
display a PWR
SUPPLY HOT,
PRINTER HOT or
PRINT HEAD HOT
message. 1. Verify that the fan rotates
when the printer is first
powered up and when the
printer moves media or
prints.
2. Call your authorized
service representative.
FILE EXISTS
Enable Overwrite Yes The printer operator
tried to save a file
using the name of an
existing stored file. Enter the PRINTER
CONTROL menu and enable
the Overwrite Files feature to
overwrite the existing file.
FILE SYS FULL
Add Flash Yes/No Insufficient flash
memory available to
store file. Install a larger flash memory
SIMM. For additional flash,
contact your authorized service
representative.
FILE SYS FULL
Delete Files Yes Insufficient flash
memory available to
store file. Enter the PRINTER
CONTROL menu. Use Delete
Files to delete unwanted files.
FILE SYS FULL
Optimize & Reboot Yes Insufficient flash
memory available to
store file. Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
FILE SYS INVALID
Optimize&Reboot Yes/No File system not
detected or flash was
corrupted. Enter the PRINTER
CONTROL menu and use the
Optimize & Reboot feature.
FILE SYS WRITE
Check Flash Yes/No Problem writing to flash
memory. Power off the printer for 15
seconds, then power back on.
If the problem persists, contact
your authorized customer
service representative.
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution