Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 322)

322
Chapter 6 Restore The Printer To Operation
DO NOT POWER
OFF No This is a standard
warning message that
displays while the
printer is downloading
software. Do not power off the printer
until downloading is complete.
DOWNLOADING TO
VALIDATOR Yes Normal message when
the printer is
downloading emulation
software with a
validator option
installed.
NOTE: Many software
builds contain updates
to the Validator option. No action required.
NOTE: The validator software
update can be verified in the
F/W Revision menu option of
the VALIDATOR menu. Shown
as: Example X326
E00 EXE @ ADDR0
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
E01A TYPE 0x40
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
E01B TYPE 0x60
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution