Printronix SL5000r RFID Smart Label and Thermal Printers User Manual
Page 156
156
Chapter
3
PRINTER CONTROL
Ptx Setup Parse
•
Enable. Will parse and execute the PTX SETUP commands.
•
Ignore. Will parse the PTX SETUP commands but not act on them.
•
Disable. Will not parse the PTX SETUP commands so they will print out
as text.
The factory default is Enable.
PJL Control
•
Enable. Will parse and execute the PJL commands.
•
Disable. Will not parse the PJL commands; they will not print out as text.
The factory default is Enable.
Glob Mem Adjust
This menu allows you to adjust the ratio of global memory allocated to label
size versus PGL forms, fonts, and logos. For example, when using short
labels, you can allocate more memory to forms, fonts, and logos by increasing
the Glob Mem Adjust value.
The amount of installed DRAM is 32 (MB). The range is from 0 to 12160
KBytes and the default is 9120 KBytes.
NOTE: Due to the large amount of memory required for font support, the
global memory adjust option is not available for P7000 H-Series
printers.
Max Font Buffer
The maximum amount of DRAM allocated to store the global font information
of any resident and downloaded scalable font (e.g. Intellifont, TrueType).
Each font contains its own global font information that is required for all
character generation from that font. Some fonts may require more font buffer
memory than others to generate characters. Insufficient font buffer memory
causes characters to be missing on the page and prints blank. If a font needs
more memory for character generation, increase the Max Font Buffer value to
allow the printer to print the missing character.
The range is from 100 to 1800 Kbytes, and the factory default is 100 Kbytes.