Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 326)

326
Chapter 6 Restore The Printer To Operation
E06 NOT ALIGNED
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
E07 ILLEGAL INS
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
E08 FLOATINGPNT
See User Manual Yes An illegal or
unsupported
instruction was
attempted in the
application program. 1. Cycle Power. Run the print
job again. If the message
appears, load the latest
emulation software.
2. Cycle power. Run the print
job again. If the message
appears, record the display
message and send it to
your next higher support
facility.
E-NET INIT Yes Ethernet is initializing. No action required.
E-NET READY Yes Ethernet has finished
initializing. No action required.
E-NET RESET Yes Ethernet interface is
being reset. No action required.
EC SOFTWARE FAIL
See Manual Yes/No Engine control
software failure. Power off the printer for 15
seconds, then power back on.
If the problem persists, contact
your authorized customer
service representative.
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
Can User
Correct?
Explanation Solution