Printronix SL5000r RFID Smart Label and Thermal Printers User Manual
Page 252
252
Chapter
3
SERIAL PORT
The factory default is Disable.
Framing Errors
These are possible errors that can occur when serial interface settings of the
printer do not match those of the host computer.
•
Enable (factory default). If a framing error occurs, a fault message will
display on the control panel.
•
Disable. If a framing error occurs, a fault message will not display on the
control panel.
Offline Process
•
Disable (default). When set to disable, the printer does not process serial
data while offline.
•
Enable. When set to enable, the printer continues to process (but not
print) the current serial job while the printer is offline until the printer’s
buffer is full.
Table 10. ENQ Status Byte
Bit
Printer Status
0
Set when the label has printed.
1
Set when the label is presented.
2
Set while the printer is online.
3
Always set.
4
Set printing in the batch mode.
5
Set during a Ribbon fault.
6
Set during a Paper Out fault.
7
Set during a Head Open fault.