Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 106)

106
Chapter 3 QUICK SETUP
QUICK SETUP
QUICK
SETUP
(from page 95)
Print
Intensity
Print
Speed
Print
Mode 8
-3*
-15 to 15 6 ips*
1 ips to 10 ips
1
Transfer*
Direct
Media
Handling
Tear-Off Strip*
Tear-Off
Peel-Off
Cut
Continuous
Paper Feed
Shift
0.00 inches* 2
-1.00 to X inches 3
Label
Length 9
4 or 6 inches* 2, 4
00.1 to 99.0 inches
5
Label
Width 9
4.1, 6.6, or 8.5 inches*
2, 4
00.1 to 8.5 inches 4
Ver Image
Shift
0.00 inches
2
-1.00 to X inches 3
Hor Image
Shift
0.00 inches*
2
-1.00 to 1.00 inches
Orientation
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
Gap/Mark
Sensor 6
Disable*
Mark
Gap
Advanced Gap
Advanced Notch
Auto Calibrate
Run Calibrate
Validator
Funct. 7
Enable*
Disable
Active IGP
Emul
IGP/PGL*
PPI/ZGL
PPI/TGL
PPI/IGL
PPI/STGL
PPI/DGL
PPI/MGL
PPI/IEGL
IGP/VGL
Save Config.
1*
1-8
Notes:
* = Factory Default
1 Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2 You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User is
enabled.
3 Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4 Maximum value depends on the width of the printer model (see Appendix A, “Specifications”).
5
Maximum value depends on model width and size of DRAM installed (see Appendix A, “Specifications”).
6 Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 138. If you change the
Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
7 Appears only if a validator is installed.
8 This menu will not appear on Direct Thermal only printers.
9 Resolution changes based on “Label Resolution” menu under MEDIA CONTROL if Small Label Printer is installed.
10 xxx represents the emulation name selected in the Active IGP Emul menu.
Power-Up
Config.
Factory*
1-8
xxx
Diagnostics 10
Disable*
Enable