EVS XEDIO CleanEdit Version 4.35 - August 2013 User Manual - Manual (Page 130)

To select all elements (entire elements) … Proceed as follows:
from the nowline
up to the end of the edit,
Click or press .
from the beginning of the edit
up to the nowline,
Click + or
press +
between the mark IN and mark OUT
Click + or
press +
7.3. Placing Clips onto the Timeline
7.3.1. Introduction
Various Methods to Add Clips to an Edit
There are many different ways to add clips onto your edit. The main methods for placing a
clip to your edit are the following ones:
• Dragging the clip into the Clip zone when the Fill button is active.
This adds the clip to the end of the timeline.
• Dragging the clip from the Clip zone to a given position in the edit.
• Dragging the clip from the Player to a given position in the edit.
Possible Positions of a Clip in an Edit
Depending on the Insert/Overwrite mode you have selected, you can drag a clip to the
following positions into the timeline:
• at the end of the clip
• on a transition
• on the nowline
• on a mark IN or mark OUT point
• between a mark IN and mark OUT points
• anywhere in the edit
This will be explained in details in the following sections.
7.3.2. Important Prerequisites
Introduction
Before you drag a clip into an edit, you always need to perform the following actions:
114 7. General Editing
EVS Broadcast Equipment SA Issue 4.35.B - August 2013