Toshiba VF-FS1 - Manual (Page 70)

E6581381
E-4
5
5.2 Specifying an operation mode, using parameters
CW : Parameter setting macro function
• Function
Automatically programs all parameters (parameters described below) related to the functions by selecting
the inverter's operating method.
The major functions can be programmed simply.
[Parameter setting]
Title Function Adjustment range Default setting
CW Parameter setting macro function
0: Disabled
1: Coast stop
2: 3-wire operation
3: External input UP/DOWN setting
4: 4-20mA current input operation
0:
Note:When this parameter is invoked after it has been set, is always displayed (on the right side).
The number on the left side refers to the number specified previously.
Example
Automatically programmed functions and parameter set values
Relational
parameter Default setting
value 1: Coast stop 2: 3-wire
operation
3: External input
UP/DOWN
setting
4: 4-20mA
current input
operation
EOF 0: Terminal board 0: Terminal board 0: Terminal board 0: Terminal board 0: Terminal board
HOF 1: VIA 1: VIA 1: VIA
5: UP/DOWN
from external
contact 1: VIA
H (Always) 1: ST 0: Disabled 1: ST 1: ST 1: ST
H (F) 2:F 2:F 2:F 2:F 2:F
H (R) 3:R 1:ST 49:HD 41:UP 6:S1
H (RES) 10: RES 10: RES 10: RES 42:DOWN 10: RES
H 0 (%) - - - 20 (%)
⇒ See K-14 for input terminal functions.
Disabled (CW=)
The parameter does nothing. Even if set to , CW will not return the setting you made to its factory
default.