Toshiba VF-FS1 - Manual (Page 172)

E6581381
F-76
6
6.20.6 Selection of operation panel stop pattern
H : Selection of operation panel stop pattern
• Function
This parameter are used to select a mode in which the motor started by pressing the key on the
operation panel is stopped when the key is pressed.
1) Slowdown stop
The motor slows down to a stop in the deceleration time set with FGE (or H).
2) Coast stop
The inverter cuts off power supply to the motor. The motor comes to a stop after coasting for a while by
inertia. Depending on the load, the motor may keep running for a good long time.
[Parameter setting]
Title Function Adjustment range Default setting
H
Selection of operation panel stop
pattern 0: Slowdown stop
1: Coast stop
0
6.20.7 Display of the head of the parameters
H : Head of the parameter display selection
• Function
The parameter can be set at the front of the setting monitor mode.
If selecting “1:CWJ”, the Wizard parameter “CWH” is not displayed.
[Parameter setting]
Title Function Adjustment range Default setting
H
Head of parameter display
selection 0: AUF
1: AUH
0
6.20.8 Integral output power
H : Integral output power retention selection
H : Integral output power display unit selection
• Function
At the main power off ,it is selectable whether retention of integral output power values or not.
And also, the display unit is selectable.
STOP
RUN