Toshiba VF-FS1 - Manual (Page 181)

E6581381
G-1
7
7. Applied operation
Applied operation can be performed by selecting the frequency mode and command mode setting. However in
case the LOCAL mode is selected by key (lighting a LOC/REM lamp), frequency setting mode and
command mode are fixed operation panel key setting mode. The following explanations are applied REMOTE
mode only.
7.1 Setting the operation frequency
Applied operation can be performed by selecting the inverter frequency setting. To make settings for applied
operation, use the basic parameter HOQF (selection of frequency setting mode 1), and the extended
parameters H (frequency priority selection) and H (selection of frequency setting mode 2).
(1) Operation panel key setting (2) External potentiometer setting
F
R
RES
CC
PLC
PP
VIA
VIB
CC
F
R
RES
CC
PLC
PP
VIA
VIB
CC
VIA
V
SW3
STOP RUN STOP RUN
HOQF :
H :
Enter the number with the operation panel
keys, then press the key to conform.
(Save the setting)
HOQF :
H :
Use the parameters H to H for this
setting.
LOC
REM
ENT