Toshiba VF-FS1 - Manual (Page 59)

E6581381
D-5
4
4.2.2 How to set extended parameters
The VF-FS1 has extended parameters to allow you to make full use of its functions.
All extended parameters are expressed with H and three digits.
Basic parameters
H
H ∼H
Press the MODE key once and use the / key
to select H from the basic parameters. Press the key or the key to
change the set value. Pressing
the ENT key allows the reading of
parameter setting.
MODE
ENT
[Steps in key entry for extended parameters]
: Switches to the setting monitor mode.(Displays CWH)
: Selects "H" from basic parameters.
: The first extended parameter “HK” (Low-speed signal output frequency) is displayed.
: Selects the extended parameter whose setting needs to be changed.
: Reads the programmed parameter setting.
: Changes the parameter setting.
Saves the changed value of the extended parameter setting.
Pressing the key instead of the key moves back to the previous status.
MODE
ENT
ENT
ENT
⇒ See section 11.3 for
extended parameters.
MODE ENT