Renesas REJ10J1837-0100 - Manual (Page 98)

High-performance Embedded Workshop 3. Advanced Build Features
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
83
3.10 Customizing the High-performance Embedded Workshop linkage order
Modules are usually linked in the alphabetical order in High-performance Embedded Workshop. However, you can
specify the linkage order if you wish to.
Note:
When the SuperH or H8SX, H8S, and H8 family toolchain is in use, the Object order list box shows library files along
with object files. However, only object files matter to the linkage order. The order of library files is only used in
searching for undefined symbols.
To manually change the linkage order
1. Click [Build -> Linkage Order]. The Linkage Order dialog box opens.
2. Select the Use custom linkage order check box.
3. The Object order list box allows you to specify the linkage order of modules. Each module has a different
icon depending on where it originated from. This is shown below:
You can change the linkage order in the following ways.
• To move a single or consecutive modules
Move to top Moves the selected module(s) to the top.
Move up Switches the selected module(s) and the
previous module.