Renesas REJ10J1837-0100 - Manual (Page 233)

High-performance Embedded Workshop 15. Using the Macro-Recording Support Facility
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
218
Set Current Project - -
Insert Project - -
Project
Edit Project Configuration *3 - -
Build File CTRL+F7
Build F7
Build All -
Build Multiple - -
Clean Current Project - -
Clean All Project - -
Build *1
Build Configurations *4 -
Debug Sessions *5 -
Reset CPU -
Go F5
Reset Go SHIFT+F5
Free Go *3 -
Go to Cursor -
Set PC to Cursor -
Run - -
Step In F11
Step Over F10
Step Out SHIFT+F11
Step - -
Auto - -
Assembly - -
Step Mode
Source - -
Halt Program -
Initialize - -
Connect *3 -
Disconnect *3 -
Save Memory - -
Verify Memory *3 - -
- - Download Modules
All Download Modules - -
- -
Debug
Unload Modules
All Downloaded Modules - -
Hex -
Decimal -
Oct -
Setup Radix
Bin -
Notes:
*1. This menu is not displayed while a debug-only project "Debugger only - xxxxxx" created by High-performance
Embedded Workshop V.4.01 or later is in use.
*2. Only options Offset, File format, Filename, Access size, and Perform memory verify during download can be
recorded; Download debug information only and Download automatically on target connection are not
recordable.
*3. Support for this function depends on the debugger.
*4. Selections made from the Current configuration drop-down list can be recorded.
*5. Selections made from the Current session drop-down list can be recorded.