Renesas REJ10J1837-0100 - Manual (Page 418)

High-performance Embedded Workshop 3. Commands
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
403
Software Break Setting Commands (Available when the debugger is connected)
Command Name Abbreviation
Description
SET_DISASSEMBLY_SOFT_BREAK SDB Sets or deletes a software breakpoint at the disassembly level.
SET_SOURCE_SOFT_BREAK SSB Sets or deletes a software breakpoint at the source level.
STATE_DISASSEMBLY_SOFT_BREAK TDB Enables or disables a software breakpoint at the disassembly level.
STATE_SOURCE_SOFT_BREAK TSB Enables or disables a software breakpoint at the source level.
Other Debugging Commands (Available when the debugger is connected)
Command Name Abbreviation Description
CONNECT * CN Connects the debugging platform.
DISCONNECT * DN Disconnects the debugging platform.
INITIALIZE IN Initializes the debugging platform system.
Note:
*. Support for this command depends on the debugger.
For the syntax of each command, refer to the online help.