Renesas REJ10J1837-0100 - Manual (Page 326)

High-performance Embedded Workshop 17. Using the Debugger
REJ10J1837-0100 Rev.1.00 Nov. 16, 2008
311
Lock Refresh - - Disables refresh of the Memory window.
Auto Refresh *2 - Regularly refreshes the Memory window.
Refresh Interval *2 - Specifies the refresh interval.
1byte - Data is displayed in 1-byte units.
2bytes - Data is displayed in 2-bytes units.
4bytes - Data is displayed in 4-bytes units.
Data Length
8bytes - Data is displayed in 8-bytes units.
Hex - Data is displayed in hexadecimal.
Dec - Data is displayed in decimal.
Signed Dec - Data is displayed in signed decimal.
Oct - Data is displayed in octal.
Radix
Bin - Data is displayed in binary.
ASCII - Displays memory as ASCII characters (default).
SJIS/JIS/UNICODE/EUC - - Not supported.
Float - Displays memory as single-precision floating point.
Double - Displays memory as double-precision floating point.
16bit Fixed - Displays memory as 16 bit fixed.
32bit Fixed - Displays memory as 32 bit fixed.
24bit Accum - - Displays memory as 24 bit accumulate.
Code
40bit Accum - - Displays memory as 40 bit accumulate.
Label - Switches display or non-display of Label area.
Register - Switches display or non-display of Register area.
Layout
Code - Switches display or non-display of Code area.
Column - Changes the number of digits displayed.
Coverage *1 Enable - Switches display or non-display of measurement result.
Save Saves memory contents in a file.
Load Loads a memory area contents from a file.
Split - - Splits up the window display.
Toolbar display - - Shows or hides the toolbar.
Customize toolbar - - Customizes toolbar buttons.
Note:
*1. Support for this function depends on the debugger.
*2. Available only when the debugger supports this function.
17.3.2 Modifying memory contents
To change the contents of memory, follow the procedure below.
• In-place edit in the Data column.