Nortel Networks NN43001-314 User Manual

Page 78

Bandwidth Management

4. Tandem the inbound Branch Office calls by creating a dialing plan which

routes all calls destined for the Branch Office through the main office.

Advanced Configuration Notes

1. The default values for Cpl, Cj, Cd, Cr and CQos can be increased to

increase the response time for Sliding Maximum changes. However,
increasing them can cause the Sliding Maximum to temporarily decrease
to a lower value then necessary, resulting in the needless blocking of
interzone calls.

2. Increasing the value of ZQRT will increase the speed at which the

Sliding Maximum increases. The same effect can be achieved by
decreasing ZQRTI. However, changing these values can cause the
Sliding maximum to oscillate until the network degradation is removed.

Configuration using Element Manager

Element Manager can be used to enable and configure the feature.

The zone must exist before it can be configured for Adaptive Network
Bandwidth Management. Refer to IP Peer Networking: Installation and
Configuration (NN43001-313) for instruction on how to create and configure
basic properties of the zone.

To configure the Adaptive Network Bandwidth Management feature, select
a zone on the Zones web page (see

Figure 14 "Zones web page" (page

66)

) and click Adaptive Network Bandwidth Management and CAC. The

Adaptive Network Bandwidth Management and CAC web page opens,
as shown in

Figure 21 "Adaptive Network Bandwidth Management and

CAC web page" (page 79)

ATTENTION

Do not configure Adaptive Networks Bandwidth Management for Zone 0 or Virtual
Trunk zones.

Nortel Communication Server 1000

Branch Office Installation and Commissioning

NN43001-314