Password requirements, Installing an ip phone using the keypad – Nortel Networks NN43001-314 User Manual
Page 265
Installing and configuring IP Phones
265
At the Branch Office, under a Branch User registration request (plugging
an IP Phone into a jack), the main office Call Server checks the configured
terminal type against the IP Phone type and configuration. This check
occurs at the Branch Office.
At the main office, under a Branch User registration request, the main office
Call Server checks for a match of the configuration to the IP Phone type. If
they do not match, registration is blocked.
Password requirements
To configure Branch User-specific data from the IP Phone keypad, a main
office password and a branch password are required.
If you configure an IP Phone Installer’s Password or a Temporary IP
Phone Installer’s Password, you can delegate these tasks and continue to
configure the system based on CS 1000E Installation and Configuration
NTP (NN43041-310). If the Branch Office is a converted Small System,
refer to Communication Server 1000M and Meridian 1 Small System
Installation and Commissioning (NN43011-310).
To install an IP Phone at the Branch Office using Set-Based Installation,
Nortel strongly recommends that an IP Phone Installer’s Password or a
Temporary IP Phone Installer’s Password be configured on the MG 1000B
Signaling Server. See
Procedure 10 "Setting the IP Phone Installers
for information on configuring the passwords.
To configure the Branch User from an IP Phone in the main office, one
of the following is required:
•
IP Phone Installer’s Password or Temporary IP Phone Installer’s
Password configured on the main office Signaling Server. The
Temporary IP Phone Installer’s Password is usually implemented to
enable a "trusted" user to install telephones at the MG 1000B.
•
Station Control Password (SCPW) for the IP Phone configured on the
main office Call Server. This is not the usual option, since usually a
trusted user or administrator installs IP Phones. An SCPW is a user
password.
Installing an IP Phone using the keypad
Before proceeding to install an IP Phone using the keypad, be sure to
obtain the required passwords, as described in
The procedure to install an IP Phone through the telephone interface
consists of three steps.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.