Configuring the dialing plan – Nortel Networks NN43001-314 User Manual
Page 298
298
Dialing plan configuration
•
At the main office, configure the Branch Office zone properties in
LD 117, excluding the ZACB and ZDP properties. Refer to IP Peer
Networking Installation and Commissioning (NN43001-313) for details.
•
At the main office, configure the routing for PSTN access.
•
At the Branch Office, configure the routing to enable calls made from
TDM or IP Phones in Local Mode to access the PSTN.
•
At the Branch Office, configure Vacant Number Routing (VNR).
•
Configure IP Phones with the same zone number at both the main office
and the Branch Office. Nortel also recommends that the Prime DNs
be the same at both the main and the branch offices. If different DNs
are configured, the dial-in numbers change when the Branch Office is
in Local Mode.
•
Assign unique individual DNs as Branch User Identities (BUID) to
Automatic Call Distribution (ACD) telephones.
Configuring the dialing plan
The steps to configure the dialing plan for MG 1000B PSTN access are:
•
At the main office (see
Procedure 33 "Configuring the main office"
):
1. Configure the ZACB property for the Branch Office zone.
2. Configure the ZDP property for the Branch Office zone.
3. Configure the Route List Index.
4. Configure the ESN Special Number and Digit Manipulation.
•
Configure the NRS (see
Procedure 34 "Configuring the NRS database"
):
1. Access NRS Manager.
2. Select an endpoint.
3. Configure the Numbering Plan Entry for the Branch Office.
•
At the Branch Office (see
Procedure 35 "Configuring the Branch Office"
):
1. Configure the Route List Index.
2. Configure ESN.
These steps can be done using overlays, as described in this section,
or in Element Manager and NRS Manager. Refer to IP Peer Networking
Installation and Commissioning (NN43001-313) for more details.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.