Nortel Networks NN43001-314 - Manual (Page 215)

IP Phone passwords and parameters 215
Step Action
1 Select IP Network > Zones in Element Manager navigator.
The Zones window opens ( Figure 66 "Branch Office-specific zone
configuration" (page 213) ). The zone list is the main window used
for zone configuration.
In the Zone List window, select the zone to be configured. The
following properties can be configured:
• Basic Property and Bandwidth Management – see Figure 67
"Branch Office-specific Zone Basic Property and Bandwidth
Management" (page 214)
• Dialing Plan and Access Codes – see Figure 115 "Zone Dialing
Plan and Access Codes" (page 312)
• Emergency Service Information – see Figure 116 "Zone
Emergency Service Information" (page 327)
• Time Difference and Daylight Saving Time Property – see Figure
68 "Zone Time Difference and time zone" (page 214)
—End—
IP Phone passwords and parameters
Procedure 10 "Setting the IP Phone Installers Password" (page 215)
enables any trusted user to install a telephone from its keypad interface.
Both main office and branch passwords are required.
Procedure 10
Setting the IP Phone Installers Password
Step Action
The IP Phone Installer’s Password is configured on one Signaling Server or
Voice Gateway Media Card in a node. The passwords are then applied to
all components in the node.
Users must use the Temporary IP Phone Installer’s Password if the SCPW
is not configured.
1 From a computer terminal connected to the Signaling Server, open a
command line shell at the main office TPS node.
2 For a permanent IP Phone Installer’s Password, enter the CLI
command
nodePwdSet . For a Temporary IP Phone Installer’s
Password, enter the command nodeTempPwdSet . The command,
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.