Installing cards – Nortel Networks NN43001-314 User Manual

Page 227

Installing an MG 1000B Core

227

b. Follow the instructions in Telephony Manager 3.1 Installation

and Commissioning (NN43050-300). A sample printout of the
Ethernet configuration is provided.

Do not connect a serial port to the AUX connector. It can damage
the port.

Set DIP switches on the power supply for the desired ringing voltage,
ringing frequency, and message waiting voltage. These procedures
are in Communication Server 1000S: Installation and Configuration
(NN43031-310).

Connect the system to an AC power source. Make sure that the
source matches the label on the back of the MG 1000B Core. Turn
the power switch to "ON".

Figure 72
Power switch on the front of the MG 1000B Core

Install any remaining equipment, such as alarms. See
Communication Server 1000E: Installation and Configuration
(NN43041-310).

Reinstall the front covers on the MG 1000B Core and MG 1000B
Expander.

—End—

Installing cards

In the MG 1000B, install Media Cards. To install and configure the 8- or
32-port Media Card (see

Figure 73 "Media Card" (page 228)

) or the 24-port

ITG-P card, refer to IP Line Fundamentals (NN43100-500).

Nortel Communication Server 1000

Branch Office Installation and Commissioning

NN43001-314

01.02

Standard

Release 5.0

20 June 2007