Figure 99 set-based installation step 7, Figure 100 set-based installation complete – Nortel Networks NN43001-314 User Manual
Page 269

Installing and configuring IP Phones
269
Figure 98
Set-Based Installation Step 7
8
Replace the handset when you hear a relocation tone and see "OK"
on the screen display.
9
The IP Phone is now registered with the Call Server. Wait
approximately ten seconds for the key map download to complete.
The IP Phone is now fully operational in Local Mode. The screen
appears as shown in
Figure 99 "Set-Based Installation complete"
.
Figure 99
Set-Based Installation complete
10
Test for survival functionality by making and receiving a call on the
telephone.
11
The telephone is now configured for basic operation and survivability.
To configure the Branch User, see
"Branch User Config" (page 270)
—End—
You must also configure the Set-Based Removal feature prompts SRCD (LD
15) and AREM (LD 57) by following
Procedure 11 "Setting and changing the
Station Control Password Configuration" (page 216)
.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.