Nortel Networks NN43001-314 User Manual
Page 211
Zone parameters
211
Prompt
Response
Description
- VPNI
(0)-16283
Virtual Private Network Identifier for Bandwidth Management
feature
0 or X = Disables feature
1-16383 = Enables feature
2
Configure the Branch Office zone.
Configure the zone properties for IP telephony bandwidth
management. Use LD 117 or Element Manager. Refer to IP Peer
Networking Installation and Commissioning (NN43001-313) .
The Branch Office zone number and zone bandwidth management
parameters at the main office must match the corresponding Branch
Office zone number and zone bandwidth management parameters
at the Branch Office.
ATTENTION
IMPORTANT!
Zone 0, the default zone, must not be configured as a Branch Office zone.
Network Bandwidth Management does not support zone 0. If zone 0 is
configured as a Branch Office zone, the Bandwidth Management feature
is not activated.
LD 117 Define zone properties for the Branch Office.
Command
Description
NEW ZONE
Create a new zone with the following parameters:
•
xxx = 0-255 zone number
•
intraZoneBandwidth = Intrazone available bandwidth (see Note
0-1000000 Kbps
•
intraZoneStrategy = Intrazone preferred strategy (BQ for Best Quality or
BB for Best Bandwidth) (see Note
If the Network Bandwidth Management feature is going to be used, the intraZoneBandwidth
and interZoneBandwidth parameters must be set to the actual available bandwidth. Refer to
"Bandwidth Management" (page 55)
If the Network Bandwidth Management feature is going to be used, and the zone is going to be
associated with a Virtual Trunk, the intraZoneStrategy and interZoneStrategy parameters must be
set to BQ. Refer to
"Bandwidth Management" (page 55)
.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.