Nortel Networks NN43001-314 - Manual (Page 246)

246 MG 1000B software installation
Procedure 21
Configuring the ELAN network interface IP address
Step Action
To configure the active ELNK Ethernet interface for the Branch Office:
1 Go into LD 117.
2 Create host entries with IP address on the ELAN subnet. Enter the
following command:
NEW HOST
3 Configure the ELAN network interface subnet mask. Enter the
following command:
CHG MASK
where
= nnn.nnn.nnn.nnn
4 Configure a new Routing Entry. Enter the following command:
NEW ROUTE
where
is the ELAN network interface IP address
of the Media Card on the MG 1000B Core
is the ELAN network interface IP address of the
MG 1000B Core
5 Verify the IP address for the Ethernet link. Enter the following
command:
PRT ELNK
6 Activate New Host entry. Enter the following command:
CHG ELNK ACTIVE
7 Save the ELAN network interface configuration. Enter the following
command:
UPDATE DBS
8 For the changes to take affect, enter the following commands in LD
137 to disable and enable the ELNK:
DIS ELNK
ENL ELNK
—End—
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.