IBM INFO PRINT 3000 - Manual (Page 92)

Powering Off the System
For duplex systems operating in duplex mode and for simplex systems, you must
switch power off to the complete system whenever you want to switch power off
to any single element. However, for duplex systems operating in dual simplex
mode, you do not have to switch power off to the complete system to power off
any single element.
In Host-Controlled Remote Mode
1.
On the Display Touch Screen, from the Operate pull-down menu SELECT the
Shutdown/Restart procedure.
2.
On the Shutdown/Restart window, SELECT the Shutdown pushbutton.
(In dual simplex mode, on the Shutdown/Restart window SELECT the
Shutdown pushbutton, for the other printer if desired.)
Wait for a Shutdown Complete message to appear on the Display Touch Screen.
(In dual simplex mode, this message appears only if both printers are
shutdown.)
3. Inform the host system console operator that you want to switch power off to
the system.
4. The host console operator will inform you when both printers have been
switched offline at the host.
5. The host system console operator switches power off to the system remotely.
In Local-Controlled Mode
1. On the Display Touch Screen from the Operate pull-down menu, SELECT the
Shutdown/Restart procedure.
2. On the Shutdown/Restart window, SELECT the Shutdown pushbutton.
(In dual simplex mode on the Shutdown/Restart window, SELECT the
Shutdown pushbutton for the other printer if desired.)
Wait for a Shutdown Complete message to appear on the Display Touch Screen.
(In dual simplex mode, this message appears only if both printers are
shutdown.)
3. Press the AFCCU Power Off if in Local switch for any combination of
powered-on elements.
Emergency Power Off
In case of an emergency, you can set the Unit Emergency to Power Off to remove
all power from the frame (PUM or AFCCU) in which the switch is installed and
from the attached printer engine. This action on one of the system printers does
not effect power on the other printer in the system, but causes the other printer to
be functionally inoperable.
Attention!
Do not use Unit Emergency Power Off switch to switch power off to the
system unless you have an emergency. Doing so can cause loss of data and
hardware problems in the AFCCU.
60
InfoPrint 3000 Operator’s Guide