IBM INFO PRINT 3000 - Manual (Page 62)

Forms Length and Width Controls
Using This Control: Does This:
FORMS WIDTH
1
Increases or decreases the stacker width setting. You can set this
lever from 8 to 18 inches in increments of ¼ inch.
FORMS LENGTH
2
Increases or decreases the stacker length setting. You can set the
forms length from 7 to 14 inches. The length increases or decreases
in increments of one-third and one-half inch. You turn the knob
clockwise to increase the forms length. You turn the knob
counterclockwise to decrease the forms length.
The length you set with the FORMS LENGTH knob is indicated by
the LEDs on the Stacker Control Panel.
30
InfoPrint 3000 Operator’s Guide